Rainwater Harvesting Laws in Minnesota

Is it legal to collect rainwater in Minnesota?
Yes, and Minnesota regulates it through its plumbing code rather than a ban. We found no Minnesota statute that prohibits collecting rain from a roof. What the state does regulate, in chapter 4714 of Minnesota Rules (the state plumbing code administered by the Plumbing Board), is how rainwater catchment systems are built when the water is used inside a building or for uses other than lawn irrigation.
The key dividing line is the use. The code’s rainwater chapter says that catchment systems used for lawn irrigation are not covered by it. A barrel or tank that waters a lawn or garden therefore sits outside the permit rules for catchment systems, while a system that flushes toilets, washes vehicles or feeds a water feature does not.
Minnesota at a glance
- Lawn irrigation
- Not covered by the rainwater catchment chapter of the plumbing code (Minn. R. 4714.1601, section 1601.1.1).
- Combined systems
- A system that irrigates a lawn and also serves other listed uses must meet the chapter, and the irrigation part must be separated by an air gap or proper backflow protection.
- Covered uses
- Water closets, urinals, trap primers for floor drains and floor sinks, industrial processes, water features, vehicle washing facilities, cooling tower makeup and similar uses, which must be approved by the commissioner (Minn. R. 4714.1602).
- Plans and permit
- No permit for a covered system until complete plumbing plans are submitted and approved.
- Collection surface
- Roofs only, made of a hard, impervious material; not parking surfaces, surface runoff, standing water or similar non-roof surfaces.
- Water quality
- For covered systems: E. coli at or below 2.2 per 100 mL, a 100-micron or smaller filter and a minimum 3.5-log bacteria reduction.
- Drinking-water connection
- No direct connection to the potable supply; makeup water only through an air gap or reduced-pressure backflow preventer.
What the Minnesota plumbing code requires
For systems inside its scope, Minnesota Rules part 4714.1602 amends the national Uniform Plumbing Code as follows:
- Approval and plans. Installation, construction, alteration and repair of covered systems must be approved by the commissioner, and no permit is issued until complete plumbing plans are submitted and approved.
- No cross-connection. The system may have no direct connection to a potable or reclaimed water supply. Potable water can top up the system only through an air gap or a reduced-pressure principle backflow preventer, and an automatic makeup supply is required when rainwater runs short or the system fails. See water meters, hookups and backflow preventers.
- Cross-connection test. If any part of the system is inside a building, the plumbing contractor performs an initial cross-connection test in the presence of the local authority before the building is occupied or the system is activated.
- Materials. Supply and distribution materials follow the code’s potable-water requirements, drainage materials follow its storm drainage rules, and the collection surface must be hard and impervious.
- Roofs only. Water may not come from vehicle parking surfaces, surface runoff, standing water or similar non-roof surfaces, and roof equipment overflows, condensate and other waste may not discharge onto the collecting roof.
- Treatment. A 100-micron or smaller filter and at least a 3.5-log reduction of bacteria, with water quality limits for E. coli and odor.
- Maintenance. Part 4714.1601 sets minimum frequencies: filters and screens every three months, gutters, downspouts and roof surfaces at the start of seasonal use and monthly during it, and storage tanks, pumps, valves and warning labels at installation and every 12 months.
The U.S. EPA’s summary of Minnesota’s rules adds that storage tanks for non-potable rainwater must be labeled, that treatment devices must be designed by a Minnesota-registered professional engineer, and that the owner must keep a maintenance log. We did not read those provisions in the rule text ourselves.
A barrel for the garden
For a barrel or tank that only waters a lawn or garden, the plumbing code’s catchment chapter does not apply. The sensible precautions are the same anywhere:
- Screen the inlet and cover the barrel so debris and mosquitoes stay out, and send overflow to a garden, away from the foundation.
- Set it on a sturdy, raised base.
- Drain and disconnect it before freezing weather; Illinois Extension gives the same advice for cold-climate barrels.
- If a hose or pump connects to drinking-water plumbing, add backflow protection and ask your local plumbing inspector.
Large volumes and the DNR
The Minnesota Department of Natural Resources requires a water-use permit from anyone who withdraws more than 10,000 gallons of water a day or 1 million gallons a year. A household barrel is far below that, but a farm or large urban growing site that stores and uses rainwater at scale should ask the DNR before relying on this page. The DNR page did not open for us, so we took the thresholds from the agency text quoted in search results.
Community gardens, farms and HOAs
- Community gardens. A shared garden that irrigates from barrels is in the same position as a home garden. Indoor use, such as toilets in a garden building, falls under the plumbing code rules above. On leased or city land, get written permission before installing barrels; see land access.
- Selling produce. See irrigation water quality and food safety, and Minnesota cottage food law if you also sell foods you make.
- HOAs. We did not verify a Minnesota statute on rain barrels in homeowners associations, so read your declaration; see homeowners associations.
- Greywater. Household greywater is a separate system with its own rules; see greywater laws for gardens.
Checklist before you install in Minnesota
- Decide the use: lawn and garden irrigation is outside the plumbing code’s catchment chapter; toilets, vehicle washing and water features are inside it.
- For covered uses, get plumbing plans approved and a permit before you build.
- Collect from a hard, impervious roof only, not from a parking area or the ground.
- Never connect the system directly to drinking-water plumbing; use an air gap or reduced-pressure backflow preventer for makeup water.
- Screen and cover barrels, route overflow away from the house, and drain and disconnect them before winter.
- Check your HOA documents and your city or county rules.
Frequently asked questions
Is it legal to collect rainwater in Minnesota?
Yes. We found no state ban. Minnesota regulates rainwater catchment systems through the plumbing code (Minnesota Rules chapter 4714), and systems used only for lawn irrigation are not covered by that chapter.
Do I need a permit for a rain barrel in Minnesota?
Not under the plumbing code’s catchment chapter if the barrel is used for lawn or garden irrigation. Systems that supply toilets, vehicle washing, water features and similar uses need approved plumbing plans and a permit.
Can I use rainwater to flush toilets in Minnesota?
Yes, with an approved system. The plumbing code requires approved plans, a permit, a 100-micron filter, a 3.5-log bacteria reduction, no direct connection to the drinking-water supply and a cross-connection test.
Where can rainwater be collected from in Minnesota?
Only from roofs made of hard, impervious material. The code bars collection from parking surfaces, surface runoff and standing water.
Can I drink harvested rainwater in Minnesota?
The state rules we read cover non-potable systems only. They do not describe a drinking-water use, so ask the Minnesota Department of Health and your local building official before any drinking use.
Do I need a water-use permit from the DNR?
Only for large withdrawals: the DNR requires a permit above 10,000 gallons a day or 1 million gallons a year. A household barrel is far below that.
Can an HOA ban rain barrels in Minnesota?
We did not verify a Minnesota statute on this. Read your covenants and ask your board.
Rainwater laws in other states
Rules differ a lot from state to state. Our other state guides, with the general rainwater harvesting laws overview:
- Arizona
- California
- Colorado
- Florida
- Georgia
- Illinois
- Indiana
- Michigan
- Mississippi
- Missouri
- Nevada
- New Mexico
- North Carolina
- Ohio
- Oregon
- Pennsylvania
- Tennessee
- Texas
- Utah
- Virginia
- Washington
Official sources
- Minnesota Rules, chapter 4714 (Minnesota Plumbing Code, Plumbing Board): part 4714.1601 (general, applicability, maintenance frequencies) and part 4714.1602 (nonpotable rainwater catchment systems), Minnesota Office of the Revisor of Statutes
- U.S. EPA, REUSExplorer: Summary of Minnesota’s water reuse guideline or regulation for onsite non-potable water reuse, industry and landscaping (tank labeling, engineer design and maintenance log)
- Minnesota Department of Natural Resources, water appropriation permit program (10,000 gallons a day and 1 million gallons a year thresholds), as quoted in published summaries
- University of Illinois Extension: Harvesting Rainwater (winter disconnect advice)
- Not checked for this page: the Minnesota DNR, University of Minnesota Extension and Minnesota Pollution Control Agency pages (they blocked automated access), the text of parts 4714.1603 and 1300.0215, Minnesota statutes on homeowners associations, and city and county permit rules